172.16.55.13 because this is a Class B address, the first two numbers (172.16) represent the network part, while the remainder of the address represents the host part (55.13).
To remove a DNS Server from the TCP/IP configuration, use the following command.Ĭ:\>netsh interface ipv4 delete dnsserver name="2" address=192.168.1.13 The device with the IP address 11.5.4.3 is not on the same network, because the first number of its IP address is different. Use winsserver instead of DNS Server in above command to configure a WINS server The primary DNS server's index is 1, the secondary DNS server's index is 2. To configure TCP/IP settings with primary and secondary DNS Server IP address, use the following command.Ĭ:\>netsh interface ipv4 add dnsserver name="2" address=192.168.100.12 index=1Ĭ:\>netsh interface ipv4 add dnsserver name="2" address=192.168.100.13 index=2 To configure the first three settings run the netsh command as shown below.Ĭ:\>netsh interface ipv4 set address name="2" source=static address=192.168.100.21 mask=255.255.255.0 gateway=192.168.100.1 A static IP address assignment means that a given computer host or device will always have the same IP address whenever connecting to the local network. Now we want to configure the the following TCP/IP settings to the Local Area Connection. Networks that support TCP/IP can make address assignments via one of two methods: static or dynamic assignment. To know the interface index number, use the netsh command as shown below.Ģ 10 1500 connected Local Area Connectionġ 50 4294967295 connected Loopback Pseudo-Interface 1 Here Local Area Connection is using an Automatic Private IP Address (APIPA).īefore start configuring the TCP/IP settings of network interface card, we need to know which interface we need to configure. A physical interface (NIC) and an ISATAP (Intra-Site Automatic Tunnel Addressing Protocol) tunneling interface. Here ipconfig /all command displays two network interfaces.
Another option that I am looking at for connecting remote Isadora patches is Virtual Private Network VPN. : Intel(R) PRO/1000 MT Network Connection This generally means configuration of remote router to be ‘listening’ to the computer specifically sending data to it over the internet and then forwarding the data to a connected computer IP address - requiring a static ip. First we need to find the current TCP/IP configuration using ipconfig /all command.